Besonderhede van voorbeeld: -8659239419929432968

English

3, clean mold - clean process is to die on the surface of a polishing agent rid of residual oil or agent and so on, then add the hole sealing agent and release agent (wax) can be firmly attached to the mold, die jie water generally wipe it twice, first to clean the surface of the water with gauze wipe in the mold and then wiped dry, then apply a layer of clean water and let its full volatile dry (about half an hour), then wipe with a clean dry cloth to light.

Chinese

3、洁模 - - 洁模过程是要将模具表面上的抛光剂残余或油剂等清除掉,使随后加上的封孔剂及脱模剂(蜡)可牢固地附在模具上,洁模水一般擦两遍,先将洁模水用纱布擦在模具表面然后抹干,再涂一层洁模水,让其充分挥发干后(约半小时 ) , 再用干净干布擦至光亮。 4、封模 - - 对于要求中等光洁度的玻璃钢产品来讲,一般用3号抛光剂抛光过即可以了。