交角 oor Engels

交角

Vertalings in die woordeboek Sjinees - Engels

inclination

naamwoord

angle at which two lines meet

angle of intersection

inclination of an orbit

naamwoord

voorbeelde

該均時差, 正常基於視運動的太陽不規則性的兩個主要組成部分,即黃赤交角與地球軌道偏心率之影響的效果,約翰·佛蘭斯蒂德的資料表直到1672/3之後,沒有被普遍採用,發表傑雷米亞·霍羅克斯之作品追授版。
The equation of time, correctly based on the two major components of the Sun's irregularity of apparent motion, i.e. the effect of the obliquity of the ecliptic and the effect of the Earth's orbital eccentricity, was not generally adopted until after John Flamsteed's tables of 1672/3, published with the posthumous edition of the works of Jeremiah Horrocks.

2008年8月,鲍奇等人通过罗斯特-麦克劳克林效应计算出柯洛2b的自旋轨道角(即中央恒星赤道面与行星轨道面的交角)约为+7.2±4.5°。
As of August 2008, the COROT-2b spin-orbit angle (that is, the angle between the equator of the star and the plane of the planet orbit) was calculated by Bouchy et al. by means of the Rossiter–McLaughlin effect with a value of +7.2 ± 4.5 degrees.

该行星并无凌日现象,这表明其交角小于88.1度。
It does not transit its star, implying that its inclination is less than 88.1 degrees.

如果交角(θ)达到了最小值即0度,那么从地球上观测到的亮度则会是发射亮度的600倍。
However, if θ is at the minimum value of 0° the jet will appear 600 times brighter from Earth.

一个卫星将在最低纬度和最高纬度之间飞越地球上的所有各点,与其交角相当。
A satellite will fly over all points of the Earth between its minimum and maximum latitudes, which are equal to its inclination.

這兩個平面的交角大約為11度。
The two planes are inclined by about 11 degrees.

在1787年,拉普拉斯利用這些測量資料來檢查黃赤交角和地球軌道離心率的變化。
In 1787, Laplace applied these measurements to check his calculations on the secular changes of the obliquity of the ecliptic and the eccentricity of the Earth's orbit.

两个球面在相交圆的所有点处的夹角都是相同的。 [14] 当且仅当它们的球心之间的距离的平方等于其半径的平方和时,它们的交角才是直角(相互正交 ) 。
Two spheres intersect at the same angle at all points of their circle of intersection.[14] They intersect at right angles (are orthogonal ) if and only if the squares of the distance between their centers is equal to the sum of the squares of their radii.[3]

附注: 您也可以在选项 对话框的建模辅助 页面中设置正交角度。
Note: You can also set the ortho angle from the Options dialog box, Modeling Aids page.

刀具和齿轮之间的轴交角和转速是影响生产率的关键性因素。
The intersecting angle between tool and gear axis and the revolution speed is decisive for productivity.